Submersible pump specifications

Submersible pump specification

Submersible pump specification is a document that standardizes the use, maintenance and care of submersible pumps, aiming to ensure the safe and efficient operation of submersible pumps and extend their service life.

Submersible pump installation requirements

1. The installation site should be selected close to the bottom to ensure that the top of the submersible pump is not exposed above the water surface.

2. The installation environment should be clean and well ventilated to prevent dust and foreign matter from entering the pump body.

3. Installation requirements There must be enough distance between the water pump and the water inlet pipe to ensure the normal suction of the water pump.

Submersible pump use requirements

1. Before use, the rotation direction of the submersible pump should be checked to ensure that it is consistent with the rotation direction of the motor.

2. During use, the operation of the submersible pump should be paid attention to at any time. If there is abnormal noise or vibration, the pump should be stopped and checked immediately.

3. It is prohibited to spray, clean, lubricate and other operations without normal decompression of the submersible pump.

4. During use, the submersible pump should be prevented from running dry, otherwise it will cause the motor to burn out, and water should be replenished in time.

Maintenance and servicing requirements for submersible pumps

1. Regularly check the status of the bearings and mechanical seals of the submersible pumps. If there is wear or leakage, they should be replaced in time.

2. Regularly check the insulation status of the motor to see if there is any damage. If there is any damage, it should be repaired in time.

3. Clean the filter regularly to prevent impurities from entering the submersible pump and affecting its normal operation.

4. Regularly check the cables and power lines of the submersible pump to ensure that the connection is firm and there is no short circuit.

5. After using the submersible pump, it should be cleaned in time and placed in a dry and ventilated place to avoid long-term exposure to the sun.

Safety precautions for submersible pumps

1. Operators should strictly follow the instructions for use of the submersible pump to avoid accidents caused by overload operation or misoperation.

2. During operation, maintenance and servicing, the power supply should be cut off, and relevant operations should be performed only after the submersible pump is shut down.

3. It is forbidden to put relevant debris, paper scraps, etc. into the submersible pump to avoid blocking the pump body.

4. During use, it is strictly forbidden to immerse the submersible pump in conductive liquid to avoid electric shock accidents.

In short, the standardized use of submersible pumps is very important to ensure their normal operation, reduce the occurrence of failures and damage, and ensure the safety of personnel and equipment. Users must strictly abide by relevant specifications when using submersible pumps to avoid safety accidents. At the same time, regular maintenance and care of submersible pumps is also necessary to extend their service life and improve work efficiency.